Page History

...

How can I change the smart card in AirID Mini?

Answer

To change a inserted smart card please follow these steps:

Panel

borderStyle	dashed
title	Step-by-Step

change a inserted smartcard please follow these steps:

To open the device, first carefully loosen the two screws on the back of the device with a PH1 cross-headed screwdriver
Then, open Open the device by carefully opening the black back part case of the enclosure (take care, the two parts of the enclosure are connected with a wire). It is important to be careful here, as the back case is connected to the rest of the device by a short cable.
Remove the inserted card by pushing the card out of the holder with your thumb to the open side (right side)
Insert your smart card (format ID-000) into the card holder. Note Make sure that the smart chip is pointing down to the connectors of the smart card holder and that the diagonal corner of the smart card is pointing facing up to the right.
Close After changing the smart card, close the device by closing the back part case of the caseenclosure again. Make sure that the battery cable is inside the enclosure while closing the device.
Position the screws in the holes of the case again and tighten the screws. Therefore, first screw to the left (counterclockwise) until the screw is positioned in the existing thread. Then, as usual, screw to the right (clockwise) and tighten until you feel a resistance while screwingof the case while tightening. This is important in order not to damage the threads of the plastic case.