Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

How can I change the smart card in AirID Mini?

Answer

To change a an inserted smart card please follow these steps:

PDF: Force Page Break

Step-by-Step
UI Steps


UI Step

Make sure the device is turned off.


UI Step
Panel
borderStyledashed
title

To open the device, first carefully loosen the two screws on the back of the device with a PH1 cross-headed screwdriver


Image Removed
Image Removed

.


Image Added Image Added

PDF: Force Page Break

UI Step

Then, open the device by carefully opening the black back case of the enclosure. 

It is important to be careful here, as the back case is connected to the rest of the device by a

short

power cable.

Image Removed


Image AddedImage Added

PDF: Force Page Break

UI Step

Remove the inserted card by pushing the card out of the holder with your thumb to the open side (right side).

Image Added

PDF: Force Page Break

UI Step

Insert your smart card (format ID-000) into the card holder.

Make sure that the smart chip is pointing down to the connectors of the card holder and that the diagonal corner of the smart card is facing up to the right.

Image AddedImage Added

PDF: Force Page Break

UI Step

After changing the smart card, close the device by closing the back case of the enclosure again.

Make sure that the battery cable is inside the enclosure while closing the device.


Image Added

PDF: Force Page Break

UI Step

Position the screws in the holes of the case and tighten the screws.

Therefore, first screw to the left (counterclockwise) until the

screw is

screws are positioned in the existing

thread

threads. Then, as usual, screw to the right (clockwise) and tighten until you feel a resistance of the case while tightening.

This is important in order not to damage the threads of the plastic case.

Image Removed


Image Added Image Added Image Added





Content by Label
showLabelsfalse
max5
spacesPM
showSpacefalse
sortmodified
reversetrue
typepage
excerptTypesimple
cqllabel = "faq" and type = "page" and space = "DEMTHSP"
labelskb-troubleshooting-article

...